Toggle Nav

GF30 Basic Cooling Setup

Lower and control the temperature of your fermentation using cold water!

The GF30 Basic Cooling Setup includes, the GF30 Conical Fermenter, which gives you a superior fermentation environment to achieve expert brewing results with every beer and the flexibility to control/monitor fermentation from anywhere thanks to built-in wireless control. Plus, with the addition of the Cooling Pump Kit, you can control fermentation with cold water by pumping it through the double walled, insulated interior, of the fermenter.

$750.00
Availability In stock
SKU
10238K-RRPUSD
All Grain Brewing
 

Lower and control the temperature of your fermentation using cold water!

The GF30 Basic Cooling Setup includes, the GF30 Conical Fermenter, which gives you a superior fermentation environment to achieve expert brewing results with every beer and the flexibility to control/monitor fermentation from anywhere thanks to built-in wireless control. Plus, with the addition of the Cooling Pump Kit, you can control fermentation with cold water by pumping it through the double walled, insulated interior, of the fermenter.

  • GF30 Conical Fermenter
  • Fermenter Lid
  • Rubber Bung
  • Bubbler Airlock
  • Cone Plug
  • Cone Plug Seal
  • 5 cm (2") Tri Clamp
  • Power Adapter and Wall Plug
  • 2 m (6.5 ft) M12 3-Pin Power Cord
  • Dual Valve Tap
  • GF30 Conical Fermenter
  • GF30 Conical Fermenter Cooling Pump (submersible)
  • T-section power connector
  • 2 x brass couplers

GF30 Conical Fermenter:

  • 304 Stainless-steel body (polished inner and brushed outer)
  • 30 L (8 US Gal) capacity (volume markings on inner body up to 25 L (7 US Gal)
  • 30 W, 12 V heating power
  • 50Hz/60Hz power adapter frequency
  • 8 cm (1.5") ferrule on lid (for pressure transfer attachments)
  • 5 cm (2") ferrule on bottom of cone
  • Dual valve tap with 110 mm (4.3”) inlet

Cooling Pump Kit:

  • 8 W, 12 VDC

 

Write Your Own Review
You're reviewing:GF30 Basic Cooling Setup
Your Rating